Contact

Tanker Procedures (Class 3) - Driver Instructions

Procedures for drivers before collection of a loaded tank.

The driver should have all necessary HazChem information to hand.

Check that the tank is not leaking.

Check the bottom outlet, shown below:

Bottom Valves

The end cap must be securely screwed onto the valve outlet.

The butterfly valve, being the main closure and the valve directly behind the end cap, must be securely closed. The above picture shows the butterfly handle in the closed position, i.e flat against the tank.

The foot valve should be closed; this is the up position. It is the lever to the right of the valve outlet.

It is important to understand the order of the three ‘closing mechanisms’. The foot valve, or emergency brake, closes next to the product. In the event of an accident it is designed to close off the flow of the product quickly; activate it by applying pressure to it with your foot!

The butterfly valve is next and is the ‘main’ closure. The end cap is last.

Top Valves & Openings

The manlid, which is situated on the top of the tank, usually towards the front, must be bolted closed.

The airline valve must be in the closed position. (If it is not closed it is possible to get a back flow of product coming out of the valve and, if hoses are in place from the airline valve (as an integral part of the tank’s fittings) the product will run out of the hose when the load is moving). The valve is normally a small T; the one shown below being in the closed position.

Procedures for drivers on collection of an empty tank.

Confirm with the receiving team that the tank is empty and ready to go, and determine whether or not it has been cleaned.

Ensure that all hoses and earthing wires have been disconnected.

Ensure the foot valve and the butterfly valve are securely closed.

Check that the end cap has been screwed securely back into place.

Check that the manlid and air valve are closed.

Remember that an empty unclean tank is still classified as dangerous and therefore must be correctly labelled and the driver should have all necessary HazChem information to hand.